Forum

 View Only

  • 1.  Report submission failed

    Posted 02-14-2019 06:15
    Colleagues would be able to carry out the implementation in the ISM to carry out a scheduled report resend.

    For example: I have several reports scheduled in my Slice, but sometimes it happens to fail to send.

    And then I have to perform manual submission using the "run now" option.

    I wish there was an option in the "Report Scheduling" as if sending failed. Try to make the same post after a few minutes.

    Is it possible to carry out this type of improvement in the ISM?

    ------------------------------
    Jefferson Pereira Macena
    IT Analyst
    Fujitsu
    ------------------------------


  • 2.  RE: Report submission failed

    Posted 02-20-2019 15:20
    @Richard Graves

    Rich sorry to bother you again.

    But I would like to know if it is possible to perform this type of update in the tool.

    As the example given:
    When there is a failure to send the report, the tool checks this failure log and resends this report again.

    Thank you. ​

    ------------------------------
    Jefferson Pereira Macena
    IT Analyst
    Fujitsu
    ------------------------------

    Original Message


  • 3.  RE: Report submission failed

    Posted 02-20-2019 15:34
    @Jefferson Pereira Macena Have you discussed this with support? I don't know if there is any inherent retry or IF Failure capabilities built into Jaspersoft, the tool we use for Advanced Reporting.                     ​

    ------------------------------
    Richard Graves
    Serviceaide
    ------------------------------

    Original Message


  • 4.  RE: Report submission failed

    Posted 03-06-2019 06:42
    Hello Rich, I opened a request for information, to verify.
    Thank you.

    ------------------------------
    Jefferson Pereira Macena
    IT Analyst
    Fujitsu
    ------------------------------

    Original Message